Archive for December, 2016

December 14th, 2016

Coat hook rails from re-cycled flooring

After putting in some new flooring, I was left with an entire box of off-fall and reject oak floor boards. To start re-cycling them I decided to make some Coat hook rails for the office.

img_20161205_224559

I surmised that they would look good using the same checkerboard end grain effect as I had previously done with a Cutting Board. So I planed down four boards to remove the finish on the top and the grooves on the bottom. I then glued the boards together in a sandwich.

img_20161205_223923

img_20161205_224028

I sliced the sandwich down to rough size with the table saw and then planed it to final thickness. The piece was then cut apart on the miter saw into the individual segments. While it did work out to make one using this technique, it was very difficult clamping all of the small strips of 4 cubes back together evenly before the glue started to set up. It also took a lot of sanding to the get the final piece smoothed out. I opted to make the two smaller rails without the checkerboard effect.

img_20161205_225828

After drilling holes for and gluing in the store bought coat hook pegs, a spray polyurethane finished was applied. I also used pre-made oak buttons to cover the two mounting holes.

img_20161209_150804